搅拌式风力致热装置启动性能研究

搭建搅拌式风力致热试验台,以自制的2种致热器为研究对象,使其分别在3个不同平均角加速度24.92、14.66、8.04 rad/s2下启动。通过动态扭矩测试仪和数据采集仪测试记录致热器启动阶段的相关数据。结果表明:致热器启动时所需扭矩与角加速度的一次方、转速、叶片半径的二次方成正比,同时得出这些因素之间的关系式;满负荷时,启动扭矩会出现一个峰值,且角加速度越大峰值越大,自然风必须提供峰值以上的扭矩,否则装置无法启动。     

New batch and continuous systems for converting hydrogen from water hyacinth

Water hyacinth was the chosen alternative biomass for H₂ production in this study. A batch and a continuous pilot plant systems are proposed. A batch system of 500?ml capacity was developed first for finding an appropriate biomass ratio which was found to be 2.5%wt. Results from the batch system was used to construct a kinetic model of water hyacinth hydrolysis. The same biomass and water ratio was used in the continuous system. Besides water hyacinth, glucose and cellulose?+?lignin biomasses were tested. During processing, temperature, pressure, and electric consumption of the system were recorded. The quality and quantity of gas products were analyzed by gas chromatography (GC). The water hyacinth biomass attained the highest rate of H₂ production (providing energy of 11.43?kWh/mole of glucose). Comparing the batch and continuous pilot systems, the continuous system achieved 2.7 times more H₂ mole% than the batch system did.     

Radon and moisture impacts from interventions integrated with housing energy retrofits

Energy retrofits can reduce air exchange, raising the concern of whether indoor radon and moisture levels could increase. This pre/post-intervention study explored whether simple radon interventions implemented in conjunction with energy retrofits can prevent increases in radon and moisture levels. Treatment homes (n = 98) were matched with control (no energy retrofits or radon intervention) homes (n = 12). Control homes were matched by geographic location and foundation type. t-tests were used to determine whether post-energy retrofit radon and moisture level changes in treatment homes significantly differed from those in control homes. The radon interventions succeeded in preventing statistically significant increases in first floor radon using arithmetic (p = 0.749) and geometric means (p = 0.120). In basements, arithmetic (p = 0.060) and geometric (p = 0.092) mean radon levels statistically significantly increased, consistent with previous studies which found that basement radon levels may increase even if first floor levels remain unchanged. Changes in infiltration were related to changes in radon (p = 0.057 in basements; p = 0.066 on first floors). Only 58% of the change in infiltration was due to air sealing, with the rest due to weather changes. There was no statistically significant association between air sealing itself and radon levels on the first floor (p = 0.664). Moisture levels also did not significantly increase.     

Accuracy of wind energy forecasts in Great Britain and prospects for improvement

The metric representing the wind energy forecast error, when reported as a percent, is calculated quite differently than the error metrics for electricity transmission, electricity load, or in other industries such as manufacturing when they are also reported as a percent. The resulting calculated metric is quite different from what would be reported if the method utilized elsewhere was employed. This paper examines the possible forecast assessment and operational challenges associated with this finding. Concerning the prospects for improvement, the errors reported in MW of energy have a systematic component. With this insight, we developed a model to improve accuracy.     

Economic Evaluation of Power System Flexibility by Commercial Air Conditioner Control with Large Penetration of Photovoltaic Generation

High penetration of intermittent renewable energy such as photovoltaic (PV) and wind power could cause shortage of power system flexibility. Demand response is expected to help supply ancillary service instead of the conventional power plant. Commercial air conditioners are a promising responsive load for demand response because they account for a large proportion of power consumption in the power system. We calculate a system operation cost and hourly operation pattern of each power plant by using the optimal power generation model considering flexibility supply from controlling commercial air conditioner. We obtained the following results as an effect of commercial air conditioner control. (1) The power generation of oil fired power plants decreases at peak time and annual fuel cost of oil fired plant is reduced by approximately 30% at most in Kanto area. (2) The percentage of rated operation mode of LNG combined cycle plants increases. (3) Curtailed energy rate of PV decreases because a power storage amount by pumped hydropower generation increases. (4) Required battery capacity to reduce PV curtailed amount decreased by combining battery energy storage system in case of high penetration of PV.     

析晶污垢生长影响因素概述

结垢问题存在于各个行业,尤其在油田表现更甚。但材料表面特性对油田采出水中析晶污垢的影响并没有得到太多关注。主要对影响析晶污垢生长的三种主要表面特性因素进行简要综述。     

What is the future of solar energy? Economic and policy barriers

The most important characteristics and limitations of solar energy were reviewed in this study. The analysis of different aspects indicated that the most important global challenges of solar energy development were climatic challenges, technical constraints, and unwillingness to make investments. After describing current conditions and predicting the future of solar energy, this study analyzed the policies formulated by developed countries to develop this from of energy. Accordingly, China has gotten ahead of other countries in this industry due to the technological production of solar panels and governmental supports. Finally, the economic estimation of solar energy was presented by dealing with the economic barriers to this form of energy in developed countries. According to the significant growth in the reduction of solar energy electricity production cost, this source of energy can be used as a major source in the future. It was then recommended to use a hybrid of solar energy with other sources such as wind to reduce the costs.     

Lewis acid-oxygen vacancy interfacial synergistic catalysis over SO42−/Ce0.84Zr0.16O2–WO3–ZrO2 for N,N-diethylation of aniline with ethanol

Herein, a new mechanism involving Lewis acid-oxygen vacancy interfacial synergistic catalysis for aniline N,N-diethylation with ethanol was proposed, and the SO₄²⁻/Ce_0.84Zr_0.16O₂–WO₃–ZrO₂ catalyst (SCWZ) with both Lewis acid sites and oxygen vacancies was synthesized by the hydrothermal method, which shows better catalytic activity than the reported solid acidic catalysts. Besides, the SO₄²⁻/ZrO₂ (SZ) and SO₄²⁻/WO₃–ZrO₂ (SWZ) catalysts were also prepared and compared with SCWZ to investigate the synergistic effect of each component. The SO₄²⁻ and WO₃ mainly generate Lewis acid by bonding with ZrO₂, which is beneficial for the fracture of the N–H bond in aniline. The Ce_0.84Zr_0.16O₂ solid solution mainly plays a vital role in generating the oxygen vacancies as the interface active species, which can participate in stripping –OH from ethanol, then the carbocation will also be released, which only needs 1.3805 kcal/mol energy, calculated by density functional theory (DFT), to be input. In comparison, the traditional reaction mechanism needs the Brønsted acidic sites to promote the protonation of ethanol, then dehydration and subsequent formation of carbocation followed, and 108.6846 kcal/mol energy needs to be input, which is far higher than that of the new mechanism. The apparent activation energy (E_a) over SCWZ was measured by experiment to be 34.09 kJ/mol, which is much lower than that of SWZ (47.10 kJ/mol) and SZ (54.37 kJ/mol), illustrating comparatively preferable kinetics for SCWZ than that of SWZ and SZ. Besides, the conversion of aniline and selectivity to N,N-diethylaniline over SCWZ reach almost 100% and 73%, respectively. The SCWZ can be renewed for 4 times without rapid deactivation, and the longevity of SCWZ is longer than that of SWZ and SZ, as the loaded SO₄²⁻ and tetragonal ZrO₂ are stabilized by Ce_0.84Zr_0.16O₂ and WO₃, respectively.     

基于CFD-DEM方法的净化器流场模拟与结构优化

针对空气净化器能耗高的问题，使用离散元方法(DEM)在吸附滤网中建立随机堆积柱形活性炭模型，采用计算流体力学(CFD)方法对空气净化器内部流场进行数值模拟，在模拟与实验验证的基础上，考察了压降最小、流场最均匀的吸附滤网结构。结果表明，空气净化器压降主要发生在轴向，活性炭吸附滤网中回流、沟流现象严重，流体阻力是其他两种滤网的3倍。边数对多边形填充孔结构吸附滤网内压降与流场均匀性无影响，当孔结构改为圆形时，压降减小约52 Pa，节能18.4%(49 W)；当孔直径由8 mm增至12 mm，压降减小约48 Pa，节能19.4%(45 W)；滤网间距对空气净化器压降无影响，圆形、小孔径的吸附滤网内流场最均匀。